Disc Makers KDC-W7027 User Manual download pdf (Page 41)

English

Installation

Locking the Backpanel to the unit

If you want to fasten the faceplate to the main

unit so that it does not fall off.

1 Refer to the Removing the Backpanel function of

the section on 'Theft Deterrent Panel' (page 17)

and remove the Backpanel.

2 Insert the panel lock screws into the holes at the

sides of the panel.

Accessory4

3 Reattach the Backpanel.

• Never insert the panel lock screws in any other screw

holes than the one specified. If you insert them in

another hole, it will contract and may cause damage to

the mechanical parts inside the unit.

• Make sure that the unit is installed securely in place. If

the unit is unstable, it may malfunction (for example, the

sound may skip).

Installation

Firewall or metal support

Screw (M4X8)

(commercially available)

Self-tapping screw

(commercially available)

Metal mounting strap

(commercially available)

Bend the tabs of the

mounting sleeve with a

screwdriver or similar utensil

and attach it in place.

• To attach this unit, make sure the front of the control

panel faces you and fit it into the mounting sleeve by

pressing the four corners of the hard rubber frame at the

same time.

Do not apply strong pressure to other sections than the

corners; otherwise troubles such as the impossibility of

opening or closing the panel may result.

• The hollow at the center of the rubber frame is designed

to make it easier to remove discs.

If you do not want the hollow to be visible, mount the

rubber frame in the opposite direction (with the flat side

at the top instead of the bottom).

B64-2750-00_U.S(E).Indd 41 03.11.27, 3:38:38 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Disc Makers KDC-W7027 User Manual Page 41

Comments to this Manuals