Disc Makers reflex series User Manual download pdf (Page 6)

• disc will be ejected when the data is loaded to the hard drive. In case

of error, the LCD will show ERROR and the master disc will be ejected

automatically.

• To begin the duplication operation, switch back to the COPY function

by pressing the STATUS button. Load the CD writers in the system with

high quality blank CD-R media. The ReflexPro will begin duplicating

when all writers detect the blank media. If four or seven writers (depend-

ing on the configuration) are not utilized, the LCD display will show the

number of CD-R blanks detected as XSTART. ( X represents the number

of writers that are ready to duplicate). Press the START button and

duplication will begin immediately.

• When the duplication process is completed, the CD writers will auto-

matically eject discs that have been duplicated properly. Discs that have

not been duplicated properly will remain in their respective writers. Press

the STATUS button and the bad discs will be ejected automatically, or

press the eject button on each individual CD writer.

• The ReflexPro will show an error message if you attempt to duplicate

from a hard drive partition that contains no data. Switch to the LOAD

function to import data to the appropriate partition.

• Do not press any buttons on the ReflexPro during the duplication pro-

cess. This will interrupt the duplication session and ruin the CD-R media.

FUNCTIONS

The Reflex features numerous functions that make it an advanced CD duplication/pro-

duction system. The following functions can be accessed on the front panel by pressing

the STATUS button.

Copy

Make sure the present partition in hard drive is correct and contains data before

copying. Place blank CD-Rs into the CD writers. When all writers detect the

CDs, the Relfex will start duplicating automatically. When fewer copies are

needed, place the required number of blank CD-Rs into the CD writers. When you see

the number X in XSTART, that matches the number of blank discs placed in the CD

writer(s). Press the START button to start duplication.

When the duplication process is finished, those discs duplicated properly will be

ejected automatically and failed ones will remain in the CD writers. Press the STATUS

button to eject those failed CD discs. Put new CD-R media in the writers for additional

duplicates.

T www.discmakers.com 1-888-800-4041 6

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Disc Makers reflex series User Manual Page 6